Changing the front panel display
You can choose how the time is shown on the front panel display, and change the brightness.
To change the time display
- Press the i button.
The display switches between the following four options:
Elapsed time for the current track
Remaining time for the current track
Elapsed time for the entire disc
Remaining time for the entire disc
To change the front panel display brightness
- Press the DIM button on the remote control to step through the three levels of illumination and blank.
If you turn the display off it will be restored briefly when you operate any control.
The display automatically dims after ten minutes; you can adjust this delay in the settings menus; see General settings.
Playing a specific track
You can play from any track by entering the track number on the remote control.
To play from a specific track
- Specify the track number by pressing one of the buttons 1–9.
To enter a two-digit track number press and hold down the button corresponding to the first digit, and then press the second digit.
To enter a three-digit track number press and hold down the 0 button, and then press the three digits.
You can play the current track repeatedly, or repeat the entire disc.
To repeat the current track
While the disc is playing:
Press the button on the remote control.
The front panel shows RPT.
To repeat the entire disc
Press the button twice.
The front panel shows RPT ALL.
To turn off repeat
Press the button again.
The RPT symbol in the display will be cleared.