SP25 and SPA25 Prisma November Update

 

Prisma firmware updates described below will be released today, 25 November, for SP25 Prisma and SPA25 Prisma.

Change logs are available below for each model, but in general, the update optimises some features and fixes bugs discovered following the last full update.

Note: SP25 Prisma and SPA25 Prisma models have been certified Roon Ready, with the update expected to be released in the next few weeks, providing that feature, as well as general bug fixes and improvements to the Prisma platform benefiting all models.

The Prisma firmware update is automatic, being automatically downloaded and installed into any internet connected Prisma device.

To confirm that the firmware update has taken place, go to the “What are the latest Prisma firmware versions?” FAQ page at this link.

If the update has not taken place in your unit shortly after the date shown in the latest firmware update table, you can manually initiate an update by rebooting the unit; turning it off and then back on using the AC mains power switch on the back panel. 

This will cause the Prisma device to do a full systems check, including checking for any new firmware updates, which will be installed if any are available.

Do allow a good twenty minutes (it should not take this long, but just to be on the safe side) for this full process to take place, being sure not to use the component during this procedure so that it can be completed without interruption.

If for some reason it is interrupted and gets stuck, simply reboot again.

Please contact us with any questions or need of assistance you may have, The Primare Team

Change Logs

SP25 Prisma – v1.53 v15542

• Corrected an HDMI EDID issue causing audio problems for systems with projectors
• Fixed an issue where audio output was silent if going from DTS format to Dirac calibration
• Optimized the PCM signal locking feature
• Solved an issue where audio output could go silent if streaming a song with same sample rate as previous song
• Rearranged Preset settings menu, moving “Speaker preset” higher in the menu list

 SPA25 Prisma – v2.77 v15542

• Corrected an HDMI EDID issue causing audio problems for systems with projectors
• Fixed an issue where audio output was silent if going from DTS format to Dirac calibration
• Optimized the PCM signal locking feature
• Solved an issue where audio output could go silent if streaming a song with same sample rate as previous song
• Rearranged Preset settings menu, moving “Speaker preset” higher in the menu list
• Corrected some OSD Help Text