These instructions help you get the best possible sound from your DD15.
The phase of the AC supply can make a significant difference to the sound.
Use the Polarity Pen supplied with the DD15 to verify which pin is live on your AC power cable.
Ensure that the live pin of the AC power cable is connected to the left-hand pin of the power connector, viewed from the back panel:
Your Primare will start to sound best after an initial burn-in of approximately 24 hours.
You will notice a further smaller improvement in sound quality for at least another 3 days’ playing.
RS232 and trigger
The Trigger output allows the DD15 to be switched on by other devices, such as an I15.
Using the DD15 with an I15
Your DD15 is an ideal companion to the Primare I15 CD Prisma Integrated Amplifier. For best results link the two products together as follows using the two cables supplied with the DD15:
To connect the trigger cable
The Trigger cable ensures that the I15 switches on, or to standby, when you operate the button on the front panel of the DD15.
- Connect the Trigger cable from the DD15 TRIG OUT to the I15 TRIG IN.
- Configure the I15 to TRIG ON.
Press and hold the standby button on the front panel to display the main firmware version number.
Press and hold the standby button on the front panel for 10 seconds to perform a factory reset of the DD15.
You can also do a factory reset from the Prisma app, or from the GENERAL SETTINGS menu; see General settings.